Kinetiq K3000 — Help Centre

1. Place the folded deck on a flat, level floor with 2m of clear space behind it.
2. Raise the upright posts until they click, then bolt both sides and tighten fully.
3. Fit the console and push the console cable in until firm.
4. Insert the magnetic safety key — the display won't power on without it.
5. Plug in, switch on at the mains, and you're ready to walk.

Prefer to watch? ▶ Watch the instruction manual.

1. The K3000 is a slim walking pad — there is no running deck to fold up.
2. If fitted, fold the handlebar/riser down, then simply slide it flat under a desk, sofa or bed.
3. Roll it on the built-in wheels and store on a flat surface.

▶ Watch the setup & folding video

• Use 100% silicone treadmill oil only — never WD-40 or household oils.
• Lift each belt edge and apply oil along both sides of the deck, then walk slowly for 2–3 minutes.
• Re-oil every 3 months or ~40 hours of use.

▶ Watch the lubrication video

1. Find the two tension bolts at the rear roller (left & right), adjusted with the supplied Allen key.
2. Drifting left: turn the left bolt ¼ turn clockwise. Drifting right: the right bolt ¼ turn clockwise.
3. Slipping under foot: turn both bolts ¼ turn clockwise, equally.
4. Test at ~6 km/h between small adjustments. Don't over-tighten.

▶ Watch the belt-alignment video

1. Check the safety key is fitted and the switch by the power lead is on.
2. Turn off at the mains for 30 seconds, re-seat the safety key and console cable, then power back on.
3. If an error code returns, note it exactly (e.g. E1) and send it to us using the contact details, or ask the AI assistant.

Your K3000 is covered by the Kinetiq manufacturer warranty. Keep your order number and the model + serial number (on the frame label) handy. To register or raise a claim, use the contact details on this page.